Filter
Top Products
Chapter 12 Troubleshooting
109
View Rotated
90 Degrees CCW
Figure 12-3. Battery on System Board
7. Insert the new battery with the positive sign (+) facing up in the socket.
8. Press down on the center of the battery with your thumb, pushing the battery
down into the socket.
The battery should snap into place.
9. Ensure the spring latch holds the battery firmly.
10. If necessary, replace the PCI board and replace the top cover.
11. Re-install the Netserver into the rack.
12. Power on the Netserver and reset the CMOS settings.
Problems Running the Setup Utility
If you cannot run the Setup Utility, the HP Netserver's configuration in CMOS
memory may have become corrupt. The only way to recover from a corrupted
configuration is to clear it. Refer to "Clearing the CMOS Configuration," earlier in
this chapter.