HP (Hewlett-Packard) BMD00022 Switch User Manual


 
Configuration Menu 118
IMPORTANT: If TACACS+ is enabled, you must login using TACACS+ authentication when
connecting via the console or Telnet/SSH/HTTP/HTTPS. Backdoor for console is always enabled,
so you can connect using notacacs and the administrator password even if the backdoor
(bckdoor) or secure backdoor (secbd) are disabled.
If Telnet backdoor is enabled (bckdoor ena), type notacacs as a backdoor to bypass
TACACS+ checking, and use the administrator password to log into the switch. The switch allows
this even if TACACS+ servers are available.
If secure backdoor is enabled (secbd ena), type in notacacs as a backdoor to bypass
TACACS+ checking, and use the administrator password to log into the switch. The switch allows
this only if TACACS+ servers are not available.
NTP server configuration
Command: /cfg/sys/ntp
[NTP Server Menu]
prisrv - Set primary NTP server address
secsrv - Set secondary NTP server address
intrval - Set NTP server resync interval
on - Turn NTP service ON
off - Turn NTP service OFF
cur - Display current NTP configuration
This menu enables you to synchronize the switch clock to a Network Time Protocol (NTP) server. By
default, this option is disabled.
The following table describes the NTP Server Configuration Menu options.
Table 84
NTP Server Configuration Menu options
Command Description
prisrv <IP address>
mgt|data
Configures the IP addresses of the primary NTP server to which you want to
synchronize the switch clock.
By default, the mgt option for the management port is used. To use data
ports, specify the data option.
secsrv <IP address>
mgt|data
Configures the IP addresses of the secondary NTP server to which you want to
synchronize the switch clock.
intrval <1-44640>
Specifies the interval, that is, how often, in minutes (1-44640), to
resynchronize the switch clock with the NTP server. The default is 1440
seconds.
on
Enables the NTP synchronization service.
off
Disables the NTP synchronization service. This is the default.
cur
Displays the current NTP service settings.