Filter
Top Products
Information Menu 50
Layer 3 information
Command: /info/l3
[Layer 3 Menu]
route - IP Routing Information Menu
arp - ARP Information Menu
ospf - OSPF Routing Information Menu
rip - RIP Routing Information Menu
ip - Show IP information
igmp - Show IGMP Snooping Multicast Group information
vrrp - Show Virtual Router Redundancy Protocol information
sm - Server Mobility Information Menu
dump - Dump all layer 3 information
The following table describes the Layer 3 Information Menu options.
Table 26
Layer 3 Information Menu options
Command Usage
route
Displays the IP Routing Menu. Using the options of this menu, the system displays the
following for each configured or learned route:
• Route destination IP address, subnet mask, and gateway address
• Type of route
• Tag indicating origin of route
• Metric for RIP tagged routes, specifying the number of hops to the destination (1-15
hops, or 16 for infinite hops)
• The IP interface that the route uses
arp
Displays the Address Resolution Protocol (ARP) Information Menu.
ospf
Displays OSPF routing Information Menu.
rip
Displays Routing Information Protocol Menu.
ip
Displays IP Information. IP information, includes:
• IP interface information: Interface number, IP address, subnet mask, VLAN number,
and operational status.
• Default gateway information: Metric for selecting which configured gateway to use,
gateway number, IP address, and health status
• IP forwarding information: Enable status, lnet and lmask
• Port status
igmp
Displays IGMP Information Menu.
vrrp
Displays the VRRP Information Menu.
sm
Displays the Server Mobility Information Menu.
dump
Dumps all switch information available from the Layer 3 Menu (10K or more, depending
on your configuration).
If you want to capture dump data to a file, set your communication software on your
workstation to capture session data prior to issuing the dump commands.