Filter
Top Products
Configuration Menu 199
Remote Monitoring configuration
Command: /cfg/rmon
[RMON Menu]
hist - RMON History Menu
event - RMON Event Menu
alarm - RMON Alarm Menu
cur - Display current RMON configuration
Remote Monitoring (RMON) allows you to monitor traffic flowing through the switch. The RMON MIB
is described in RFC 1757.
The following table describes the RMON Configuration Menu options.
Table 182
RMON Menu options
Command Description
hist
Displays the RMON History Menu.
event
Displays the RMON Event Menu.
alarm
Displays the RMON Alarm Menu.
cur
Displays the current RMON configuration.
RMON history configuration
Command: /cfg/rmon/hist <1-65535>
[RMON History 1 Menu]
ifoid - Set interface MIB object to monitor
rbnum - Set the number of requested buckets
intrval - Set polling interval
owner - Set owner for the RMON group of statistics
delete - Delete this history and restore defaults
cur - Display current history configuration
The following table describes the RMON History Menu options.
Table 183
RMON History Menu options
Command Description
ifoid <1-127 characters>
Configures the interface MIB Object Identifier. The IFOID must correspond
to the standard interface OID, as follows:
1.3.6.1.2.1.2.2.1.1.x
where x is the ifIndex (1-16, 18-21)
The interface OID can have a maximum of 127 characters.
rbnum <1-65535>
Configures the requested number of buckets, which is the number of
discrete time intervals over which data is to be saved.
The range is from 1 to 65535. The default is 30.
The maximum number of buckets that can be granted is 50.
intrval <1-3600>
Configures the time interval over which the data is sampled for each
bucket.
The range is from 1 to 3600 seconds. The default value is 1800 seconds.