Filter
Top Products
Configuration Menu 128
Table 95 System Access Configuration Menu options
Command Description
wport <TCP port number>
Sets the switch port used for serving switch Web content. The default is
HTTP port 80.
snmp disable|read-
only|read-write
Disables or provides read-only/write-read SNMP access.
tsbbi enable|disable
Enables or disables BBI configuration control s for Telnet and SSH.
tnet disable|enable
Enables or disables Telnet access. You see this command only if you are
connected to the switch through a serial connection. The default setting is
enabled.
tnport <TCP port number>
Sets an optional telnet server port number for cases where the server listens
for telnet sessions on a non-standard port.
tport <TFTP port number>
Sets an optional telnet server port number for cases where the server listens
for TFTP sessions on a non-standard port.
cur
Displays the current system access parameters.
Management Networks configuration
Command: /cfg/sys/access/mgmt
[Management Networks Menu]
add - Add mgmt network definition
rem - Remove mgmt network definition
cur - Display current mgmt network definitions
clear - Clear current mgmt network definitions
The following table describes the Management Networks Configuration menu options. You can
configure up to 10 management networks on the switch.
Table 96
Management Network Configuration menu options
Command Description
add <IP address> <IP mask>
Adds a defined network through which switch access is allowed through
Telnet, SNMP, RIP, or the browser-based interface. A range of IP
addresses is produced when used with a network mask address. Specify
an IP address and mask address in dotted-decimal notation.
rem <IP address> <IP mask>
Removes a defined network, which consists of a management network
address and a management network mask address.
cur
Displays the current management networks parameters.
clear Clears the management network definitions.