Filter
Top Products
Configuration Menu 188
VRRP Virtual Router Group Priority Tracking configuration
Command: /cfg/l3/vrrp/group/track
[Virtual Router Group Priority Tracking Menu]
ifs - Enable/disable tracking other interfaces
ports - Enable/disable tracking VLAN switch ports
cur - Display current VRRP Group Tracking configuration
NOTE: If Virtual Router Group Tracking is enabled, the tracking option will be available only under
group option. The tracking setting for the other individual virtual routers will be ignored.
The following table describes the Virtual Router Group Priority Tracking Configuration Menu options.
Table 165
Virtual Router Group Priority Tracking Configuration Menu options
Command Description
ifs disable|enable
When enabled, the priority for this virtual router will be increased for each
other IP interface active on this switch. An IP interface is considered active
when there is at least one active port on the same VLAN. This helps elect the
virtual routers with the most available routes as the master. This command is
disabled by default.
ports disable|enable
When enabled, the priority for this virtual router will be increased for each
active port on the same VLAN. A port is considered active if it has a link and
is forwarding traffic. This helps elect the virtual routers with the most available
ports as the master. This command is disabled by default.
cur
Displays the current configuration for priority tracking for this virtual router.
VRRP Interface configuration
Command: /cfg/l3/vrrp/if <1-249>
[VRRP Interface 1 Menu]
auth - Set authentication types
passw - Set plain-text password
del - Delete interface
cur - Display current VRRP interface configuration
This menu is used for configuring VRRP authentication parameters for the IP interfaces used with the
virtual routers. The interface-number represents the IP interface on which authentication parameters
must be configured.
The following table describes the VRRP Interface Configuration Menu options.
Table 166
VRRP Interface Configuration Menu options
Command Description
auth none|password
Defines the type of authentication that will be used: none (no authentication), or
password (password authentication).
passw <password>
Defines a plain text password up to eight characters long. This password will be
added to each VRRP packet transmitted by this interface when password
authentication is chosen (see auth above).
del
Clears the authentication configuration parameters for this IP interface. The IP
interface itself is not deleted.