Filter
Top Products
Configuration Menu 151
Link Aggregation Control Protocol configuration
Command: /cfg/l2/lacp
[LACP Menu]
sysprio - Set LACP system priority
timeout - Set LACP system timeout scale for timing out partner info
port - LACP port Menu
cur - Display current LACP configuration
The following table describes the LACP Configuration Menu options.
Table 120
LACP Configuration Menu options
Command Description
sysprio <1-65535> Defines the priority value (1 through 65535) for the switch. Lower numbers
provide higher priority. The default value is 32768.
timeout short|long
Defines the timeout period before invalidating LACP data from a remote
partner. Choose short (3 seconds) or long (90 seconds). The default
value is long.
HP recommends that you use a timeout value of long, to reduce LACPDU
processing. If your switch’s CPU utilization rate remains at 100% for periods
of 90 seconds or more, consider using static trunks instead of LACP.
port <port number> Displays the LACP Port menu.
cur
Display current LACP configuration.
LACP Port configuration
Command: /cfg/l2/lacp/port <port number>
[LACP Port 2 Menu]
mode - Set LACP mode
prio - Set LACP port priority
adminkey - Set LACP port admin key
cur - Display current LACP port configuration
The following table describes the LACP Port Configuration Menu options.
Table 121
LACP Port Configuration Menu options
Command Description
mode off|active|passive
Set the LACP mode for this port, as follows:
• off—Turn LACP off for this port. You can use this port to manually
configure a static trunk. The default value is off.
• active—Turn LACP on and set this port to active. Active ports initiate
LACPDUs.
• passive—Turn LACP on and set this port to passive. Passive ports do
not initiate LACPDUs, but respond to LACPDUs from active ports.
prio <1-65535> Sets the priority value for the selected port. Lower numbers provide higher
priority. The default is 128.