Filter
Top Products
Configuration Menu 181
The following table describes the BOOTP Configuration Menu options.
Table 158
BOOTP Configuration Menu options
Command Description
addr <IP address>
Sets the IP address of the BOOTP server. For example, 100.10.1.1.
addr2 <IP address>
Sets the IP address of the secondary BOOTP server. For example,
100.10.1.2.
on
Globally turns on BOOTP relay.
off
Globally turns on BOOTP relay.
cur
Displays the current BOOTP relay configuration.
Server Mobility configuration
Command: /cfg/l3/sm
[ServerMobility Menu]
port - Server Mobility Port Menu
default - Set ServerMobility configuration to factory default
add - Add ServerMobility ports
rem - Remove ServerMobility ports
filter - Enable/Disable DHCP request message filters on ports
nsmrelay - Enable/Disable relay on non-ServerMobility ports
on - Globally turn ServerMobility ON
off - Globally turn ServerMobility OFF
cur - Display current ServerMobility configuration
The following table describes the Server Mobility Configuration menu options.
Table 159
Server Mobility Configuration menu options
Command Description
port <port number>
Displays the Server Mobility port menu.
default
Resets the Server Mobility parameters to their factory default values.
add <port number>
Configures a port as a Server Mobility port.
rem <port number>
Removes the port from Server Mobility.
filter enable|disable
Enables or disables filtering DHCP request information on the port.
When enabled, DHCP requests from the server are filtered, so that
the DHCP server receives only DHCP requests from the
HP 1:10 GbE switch.
nsmrelay enable|disable
Enables or disables BOOTP Relay for all ports that have Server
Mobility disabled. The default value is disabled.
on
Globally turns Server Mobility on.
off
Globally turns Server Mobility off.
cur
Displays the current Server Mobility settings.