Filter
Top Products
Clean the scanner glass
Dirt, fingerprints, smudges, hair and other marks on the scanner glass slows scanner performance and
affects the accuracy of special features such as fit-to-page and copy. To improve the quality of your
copies and scans, clean the scanner glass. See
Clean the scanner glass on page 195.
Adjust the lighter/darker (contrast) setting
The lighter/darker setting affects the lightness or darkness (contrast) of the copy. Use the following
procedure to change the contrast for the current copy job only.
Adjust the lighter/darker setting for the current job
1. On the control panel press Lighter/Darker.
-or-
On products with a graphical display, press Copy Menu, then use the arrow buttons to select
Lighter/Darker, and then press OK.
2. Use the arrow buttons to adjust the setting. Move the slider to the left to make the copy lighter than
the original, or move the slider to the right to make the copy darker than the original.
3. Press Start Copy to save the selection and immediately start the copy job, or press OK to save the
selection without starting the job.
NOTE: The change in the setting remains active for about 2 minutes after the copy job has been
completed. During this time, Custom settings appears on the product control-panel display.
Adjust the default lighter/darker setting
NOTE: The default lighter/darker setting affects all copy jobs.
1. On the product control panel, press Setup.
2. Use the arrow buttons button to select Copy setup, and then press OK.
3. Use the arrow buttons button to select Def. Light/dark, and then press OK.
4. Use the arrow buttons button to adjust the setting. Move the slider to the left to make all of the
copies lighter than the original, or move the slider to the right to make all of the copies darker than
the original.
5. Press OK to save the selection.
Define custom copy settings
When you change the copy settings at the control panel, Custom settings appears on the control-panel
display. The custom settings remain in effect for approximately 2 minutes, and then the product returns
to the default settings. To immediately return to the default settings, press Cancel.
Print or copy edge-to-edge
NOTE: The printed or copied page has a border of approximately 4 mm (1/6 of an inch). The product
does not support edge-to-edge printing or copying.
80 Chapter 9 Copy ENWW