Filter
Top Products
Registration page
The registration page prints a horizontal arrow and a vertical arrow that show how far from center an
image can be printed on the page. You can set registration values for a tray so that an image on the
back and front of a page is centered. Setting the registration also allows edge-to-edge printing to be set
to within approximately 2 mm (0.08 inch) of all edges of the paper. Image placement varies slightly for
each tray. Perform the registration procedure for each tray.
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight PRINT QUALITY.
5. Press
to select PRINT QUALITY.
6. Press
to highlight SET REGISTRATION.
7. Press
to select SET REGISTRATION.
NOTE You can select a tray by specifying a SOURCE. The default SOURCE is Tray 2.
To set the registration for Tray 2, go to step 12. Otherwise, proceed to the next step.
8. Press to highlight SOURCE.
9. Press
to select SOURCE.
10. Press
or to highlight a tray.
11. Press
to select the tray.
After selecting the tray, the printer control panel returns to the SET REGISTRATION menu.
12. Press
to highlight PRINT TEST PAGE.
13. Press
to select PRINT TEST PAGE.
14. Follow the instructions on the printed page.
The message Printing... REGISTRATION PAGE appears on the display until the printer finishes
printing the registration page. The printer returns to the Ready state after printing the registration page.
Event log
The event log lists the printer events, including printer jams, service errors, and other printer conditions.
1. Press Menu to enter the MENUS.
2. Press
to highlight DIAGNOSTICS.
3. Press
to select DIAGNOSTICS.
4. Press
to highlight PRINT EVENT LOG.
5. Press
to select PRINT EVENT LOG.
ENWW Troubleshooting information pages 181