Filter
Top Products
8. Press or to select the appropriate setting.
9. Press
to set the selection.
10. Press Menu.
Auto continue
You can determine printer behavior when the system generates an Auto Continuable error. ON is the
default setting.
●
ON displays an error message for ten seconds before automatically continuing to print.
●
OFF pauses printing any time the printer displays an error message and until you press
.
Setting auto continue
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight AUTO CONTINUE.
7. Press
to select AUTO CONTINUE.
8. Press
or to select the appropriate setting.
9. Press
to set the selection.
10. Press Menu.
Replace supplies
The printer allows three options for handling the printer when a color cartridge is low and should be
replaced. STOP AT OUT is the default value.
●
STOP AT LOW pauses printing until the color supply is replaced. The control panel displays a
warning that the supply is low and should be replaced.
●
STOP AT OUT allows the printer to continue printing until the color supply is exhausted. The control
panel displays a warning that the supply is out and should be replaced.
●
OVERRIDE AT OUT allows printing to continue when a color supply is out, but displays a warning
that override is in use and that the supply must be replaced.
NOTE Using the Override mode may result in unsatisfactory print quality. HP recommends
replacing the supply when the REPLACE SUPPLY message is displayed. HP Supplies Premium
Protection Warranty coverage ends when a supply is used in Override mode.
ENWW Changing printer control panel configuration settings 73