Filter
Top Products
Setting replace supplies response
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight REPLACE SUPPLIES.
7. Press
to select REPLACE SUPPLIES.
8. Press
or to select the appropriate setting.
9. Press
to set the selection.
10. Press Menu.
Order at
This menu option allows you to set the point at which you are reminded to order new supplies. The point
is measured in terms of percent remaining. The allowable range is 0-100. The default is 15.
Setting order at response
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight SYSTEM SETUP.
5. Press
to select SYSTEM SETUP.
6. Press
to highlight ORDER AT.
7. Press
to select ORDER AT.
8. Press
or to select the appropriate setting.
9. Press
to set the selection.
10. Press Menu.
Color supply out
There are two options for this menu item. The default is STOP.
●
STOP causes the printer to stop printing until the empty color supply is replaced.
●
AUTOCONTINUE BLACK allows the printer to continue printing using black toner only when a
color supply is empty. A warning message displays on the control panel when the printer is in this
mode. Printing in this mode is allowed only for a specific number of pages. After that, the printer
will pause printing until you replace the empty color supply.
74 Chapter 2 Control panel ENWW