Filter
Top Products
Setting the default gateway
1. Press Menu to enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight the JETDIRECT menu.
7. Press
to select the JETDIRECT menu.
8. Press
to highlight TCP/IP.
9. Press
to select TCP/IP.
10. Press
to highlight MANUAL SETTINGS.
11. Press
to select MANUAL SETTINGS.
12. Press
to highlight DEFAULT GATEWAY.
13. Press
to select DEFAULT GATEWAY.
NOTE The first set of the three sets of numbers shows the default settings. If there is not
a number highlighted, a highlighted empty underscore appears.
14. Press or to increase or decrease the number for configuring DEFAULT GATEWAY.
15. Press
to move to the next set of numbers.
16. Repeat steps 15 and 16 until the correct subnet mask is entered.
17. Press the Menu button to return to the Ready state.
Disabling network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
●
Decreases printer-generated network traffic.
●
Prevents unauthorized users from printing to the printer.
●
Provides only pertinent information on the configuration page.
●
Allows the printer control panel to display protocol-specific error and warning messages.
NOTE TCP/IP configuration cannot be disabled on the HP Color LaserJet 4700 series printer.
82 Chapter 3 I/O configuration ENWW