Filter
Top Products
Control panel message Description Recommended action
Restoring... The printer is restoring settings. This
message is displayed during the execution of
a restore action, such as RESTORE COLOR
VALUES.
No action necessary.
Restoring...
factory settings
The printer is restoring factory settings. No action necessary.
RESTRICTED FROM PRINTING IN COLOR
alternates with
Ready
The printer is set to COLOR IF ALLOWED
and you or your software program are not
authorized to print in color.
Get your network administrator to set the user
or program permissions that will allow you to
print in color.
Rotating <COLOR>
motor
To exit press Stop
A component test is in progress; the
component selected is the <color> cartridge
motor.
Press Stop when ready to stop this test.
Rotating motor
To exit press Stop
The printer is executing a component test and
the component selected is a motor.
Press Stop when ready to stop this test.
SANITIZING DISK X% COMPLETE
DO NOT POWER OFF
A storage device is being sanitized. Do not
turn the printer off. When the process is
complete, the printer will automatically
restart.
No action necessary.
Setting saved A menu selection has been saved. No action necessary.
SIZE MISMATCH
TRAY XX=[SIZE]
For help press
alternates with
Ready
The tray is loaded with media longer or
shorter in the feed direction than the size
configured for the tray.
1. Adjust the side and rear media guides
against the paper.
2. If necessary, press
after the tray is
closed to change the paper size or type
configuration to match the size or type
in the tray.
SLEEP MODE ON The printer is in sleep mode. A button press,
receipt of printable data, or an error condition
will clear this message.
No action necessary.
STACKER BIN FULL The stapler/stacker output bin is full. The
amber light on the stapler/stacker is blinking.
Remove paper from the stapler/stacker
output bin.
STACKER TOP COVER OPEN The jam access door is open. The stapler/
stacker cannot operate in this condition. The
amber light on the stapler/stacker is blinking.
Close the jam access door.
STACKER TOP COVER OPEN The top cover of the stacker unit is open. The
unit cannot function.
Close the top cover and resend the job.
STAPLER DOOR OPEN The stapler cartridge door is open. The
stapler/stacker cannot operate in this
condition. The amber light on the stapler/
stacker is blinking.
Close the stapler cartridge door.
STAPLER DOOR OPEN The top cover of the stapler unit is open. The
unit cannot function.
Close the top cover and resend the job.
ENWW Control panel messages 207