Filter
Top Products
Chapter 6
Removing and Replacing Components
Accessing a Rack-Mounted Server
177
Accessing a Rack-Mounted Server
The HP 9000 rp4410 and rp4440 servers are designed to be rack mounted. The following procedure explains
how to gain access to the server that is mounted in an approved rack. For rack installation instructions,
review the document titled Installation Guide, Mid-Weight Slide Kit, 5065-7291. This document can be
accessed at:
http://www.hp.com/racksolutions
WARNING Ensure that all antitip features are employed before extending the server (front and
rear antitip feet installed; adequate ballast properly placed; and so on).
Extend the Server from the Rack
NOTE Ensure that there is enough area (Approximately 1.5 meters [4.5 ft]) to fully extend the server
out the front and work on it.
To extend the server from the rack, follow these steps:
Step 1. Remove the 25-mm Torx screws that fasten the server to the rack.
Figure 6-1 Accessing T-25 Screws
T-25 Screws