Filter
Top Products
Chapter 6
Removing and Replacing Components
U320 SCSI Enablement and Conversion Procedures
236
NOTE The SCSI jumper cable bridges the two SCSI connectors on the SCSI backplane
when the server is configured for simplex operation. The SCSI jumper cable is not
installed in duplex configurations.
Figure 6-35 Remove the SCSI Backplane Jumper Cable
Step 4. Remove the hot-pluggable disk drives. (See “Removing a Hot-Pluggable Disk Drive” on page 250.)
Step 5. Turn the swivel latch on top of the hot-pluggable hard disk drive cage to unlatch the SCSI
backplane from the hard disk cage.
Step 6. Grasp the top edge of the SCSI backplane and pull up until it releases from the keyway slots on the
back of the hot-pluggable disk drive cage.