Filter
Top Products
Chapter 6
Removing and Replacing Components
SCSI Backplane
254
Figure 6-50 SCSI Backplane Removal and Replacement
Replacing the SCSI Backplane
To replace the SCSI backplane, follow these steps:
Step 1. Replace the SCSI backplane to the rear of the disk drive cage.
Step 2. Turn the swivel latch on top of the hot-pluggable hard disk drive cage to latch the SCSI backplane
to the cage.
Step 3. Replace the two hot-pluggable disk drives into the disk drive cage. (See “Hot-Pluggable Disk
Drives” on page 250.)
Step 4. Replug the SCSI backplane-to-midplane cable back into the SCSI backplane.
Step 5. Replug the internal SCSI cables into the SCSI back plane.
Step 6. Replace the processor extender board. (See “Replacing the Processor Extender Board” on page 194.)