Filter
Top Products
Chapter 6
Removing and Replacing Components
U320 SCSI Enablement and Conversion Procedures
244
Step 5. Connect the SCSI jumper cable to the SCSI backplane connectors.
Figure 6-42 Installing the SCSI Jumper Cable
Installing Server Components
To install the necessary components in the server chassis, follow these steps:
Step 1. Install the processor extender board. (See “Replacing the Memory Extender Board” on page 186.)
Step 2. Install the memory extender board. (See “Replacing the Processor Extender Board” on page 194.)
Step 3. Install the front and top covers. (See “Front and Top Covers” on page 181.)
Step 4. Install the front bezel. (See “Front Bezel” on page 180.)
Verification of Upgrade Installation
After completing the upgrade, verify that the sever is ready for operation as follows:
Step 1. Reconnect ac power to the rear panel connectors.
Step 2. Press the front panel power button to power on the server.