Filter
Top Products
Chapter 6
Removing and Replacing Components
I/O Baseboard Assembly
208
Step 8. Lift up on the locking lever attached to the side of the power supply cage to unplug the I/O
baseboard from the socket on the midplane riser board.
Figure 6-21 I/O Baseboard Locking Lever
Step 9. Slide the I/O baseboard assembly all the way to the rear until free from chassis. To replace the I/O
baseboard with a new assembly, remove the cover from the VGA port at the rear of the I/O board
and save it to put onto the VGA port of the new baseboard. This VGA graphics port is not supported
in the HP 9000 rp4410 or rp4440 servers.
OPEN
CLOSE