Filter
Top Products
Installing the System
Installing Additional Components
Chapter 3
86
Figure 3-21 Disk Drive Installation in Slot 2
Step 3. Close the drive ejector handle by pushing it down until it clicks. The hot-pluggable disk drive is now
correctly installed.
Figure 3-22 Disk Drive Installation in Slots 1 and 2
Installing Processors
This section provides information about installing processors.
WARNING Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
Slot 2—SCSI ID 1
Slot 1—SCSI ID 0