Filter
Top Products
Chapter 6
Removing and Replacing Components
Front and Top Covers
182
Step 3. Using a Torx T15 driver, loosen the four captive thumbscrews that hold the front cover in place.
Figure 6-4 Removing and Replacing the Front Cover
Step 4. Raise the cover slightly, and pull the cover toward the front of the server to free the tabs from the
slots in the center of the chassis.
Replacing the Front Cover
To replace the front cover, follow these steps:
Step 1. Align the tabs at the rear of the front cover with the corresponding slots in the chassis. Fully seat
the tabs into the slots.
Step 2. Tighten the four thumbscrews securely.
Step 3. Replace the front bezel. (See “Replacing the Front Bezel” on page 180.)
Removing the Top Cover
To remove the top cover, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See “Accessing a Rack-Mounted
Server” on page 177.)
Step 2. Loosen the two captive thumbscrews that hold the top cover in place. (Figure 6-5)
Thumbscrews