Filter
Top Products
Installing the System
Installing Additional Components
Chapter 3
85
Step 4. Supporting the power supply with both hands, slide it into slot P1 until it plugs into the socket on
the internal power supply board. Hand tighten the thumbscrew.
Step 5. Install the power cord into the power supply socket and secure it to the power cord bracket.
Step 6. Apply power (200 - 240 VAC) to the new power supply. The LED immediately turns on.
Installing Hot-Pluggable Disk Drives
One additional hot-pluggable disk drive can be added to the server in slot 2. Always use low profile disk drives
(1 inch height) in the server.
To install a hot-pluggable disk drive, follow these steps:
Step 1. Remove the volume filler from slot 2.
Figure 3-20 Volume Filler Installation in Slot 2
NOTE For cooling purposes, always leave the volume filler in slot 2 if you do not use a
second disk drive.
Step 2. Slide the hot-pluggable disk drive into slot 2 until it is seated.