Filter
Top Products
Chapter 6
Removing and Replacing Components
Processor Extender Board
194
Replacing the Processor Extender Board
CAUTION Your processor extender board can be used in Itanium or PA-RISC based systems. A dipswitch
is provided to configure processor extender board circuits. Ensure that the dipswitch is set to
PA RISC for the HP 9000 rp4410 or rp4440 servers. If this switch is set incorrectly, the system
does not enter into power on self test (POST).
To replace the processor extender board, follow these steps:
Step 1. Position the processor extender board as in Figure 6-12. There are two switch blocks.
Figure 6-12 Dipswitch Location
Step 2. Set the lower of the two blocks when the processor carrier is oriented with the extractor handles
toward you.
Lower switch block