Filter
Top Products
Installing the System
Installing Additional Components
Chapter 3
88
Table 3-7 lists the load sequence.
Removing the Processor Extender Board
WARNING Ensure that the system is powered off and all power sources have been disconnected
from the server before removing the processor extender board.
Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning can result in personal injury or damage to
equipment.
To remove the processor extender board, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See “Extend the Server from the
Rack” on page 64.)
Step 2. Remove the front bezel. (See “Removing the Front Bezel” on page 71.)
Step 3. Remove the front cover. (See “Removing the Front Cover” on page 72.)
Step 4. Press the latch on each extraction lever located on each side of the processor extender board.
Table 3-7 Dual Processor Module Load Order
Server
Dual Processor
Module
Connector
rp4410 or
rp4440
1CPU0
rp4410 or
rp4440
2CPU1
rp4440 only 3 CPU2
rp4440 only 4 CPU3