Filter
Top Products
Chapter 6
Removing and Replacing Components
DVD I/O Board
265
DVD I/O Board
The DVD I/O board is located under a metal cover that is directly above the DVD drive at the front left of the
chassis.
WARNING Ensure that the system is powered off and all power sources have been disconnected
from the server before removing or replacing a DVD I/O board.
Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning can result in personal injury or damage to
equipment.
CAUTION Failure to properly complete the steps in this procedure results in erratic system behavior or
system failure. For assistance with this procedure, contact your local HP Authorized Service
Provider.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions can result in damage to the server.
Removing a DVD I/O Board
To remove a DVD I/O board, follow these steps:
Step 1. If rack-mounted, slide the server out from the rack until it stops. (See “Accessing a Rack-Mounted
Server” on page 177.)
Step 2. Remove the front bezel. (See “Removing the Front Bezel” on page 180.)
Step 3. Remove the front cover. (See “Removing the Front Cover” on page 181.)
Step 4. Remove the memory extender board. (See “Removing a Memory Extender Board” on page 184.)
Step 5. Remove the processor extender board. (See “Removing the Processor Extender Board” on page 192.)
Step 6. Using a Torx 15 driver, remove the two T-15 screws holding the DVD I/O board cover plate to the
chassis and remove the cover plate.
Step 7. Unfasten the release clip attaching the DVD I/O board to the chassis.
Step 8. Lift out the DVD I/O board and remove the midplane riser board connector cable. Remove the DVD
I/O board from the chassis.