Filter
Top Products
Chapter 6
Removing and Replacing Components
U320 SCSI Enablement and Conversion Procedures
238
Installing the SCSI Duplex Board
Install the SCSI duplex board only if your system is configured for duplex operation. To install the duplex
board, follow these steps:
Step 1. Align the bracket tabs with the slots on the side of the disk drive cage.
Figure 6-37 Aligning the Bracket Tabs on the SCSI Duplex Board
Step 2. Press the bracket against the disk drive cage until the bracket locks into place.
Step 3. Align the connector of the duplex board with the connector on the SCSI backplane.
Step 4. Press the board connector into the backplane connector.
Step 5. Plug the SCSI cable B connector into the SCSI connector located on the backplane next to the
duplex board (Figure 6-33 on page 234).