Filter
Top Products
selected page size with the amount of printer RAM
currently installed
Disabling the Start-up Page
After you install the printer and establish communication between
the printer and the host, you may want to disable the start-up page
to conserve toner, developer, and print media. You can do this
through the printer front panel (see chapter 4, “Printer
Configuration”) or through PS Executive Series Utilities (see the
on-line help).
The Status Pages
There are two types of status pages, the standard status page (1 page
that gives the general setup), and the advanced status page (5 or
more pages that lists all menu settings and fonts and emulations).
You select the type (standard or advanced) to print through the
Administration/Special Pages/Status Page Type menu. Then, you
can print the selected type through the front panel
Administration/Special Pages/Print Status menu. (See chapter 4,
“Printer Configuration,” for details on printing from the front
panel.)
The standard status page lists printer identification information and
settings, current memory configuration, timeout values,
communication settings, input buffer sizes, and the hard disk(s)
status.
The standard status page also has alignment tickmarks in the
lower-left corner. When the printer is properly aligned, these marks
are 0.5" from the left edge and 0.5" from the bottom of the page.
Use the Image Alignment option (located in the
Administration/Engine menu), described in chapter 4, “Printer
Chapter 5
5-20 Print Media and Daily Operations