Filter
Top Products
Font and Emulation Cards
You can purchase cards containing emulations or fonts not resident
on the printer. The printer can support two cards at once, either two
font cards or a font and an emulation card. Fonts and emulation
cards may go in either of the two slots located on the front of the
printer, below the control panel. For a complete list of currently
available cards, contact your QMS vendor.
CAUTION: Usually, the printer must be off line before you insert
or remove a card. Press the Online/Offline key to turn the LED off.
If you forget to take the printer off line, turn the printer power off
and back on to regain access to the printer’s resident fonts and the
data stored in the printer’s memory.
However, before installing or removing the LN03 Plus or the
ProCollection font card, you must turn off your printer rather than
just take it off line. Then turn the printer back on after you finish.
Using Font and Emulation Cards
Use the following procedure to install a font or emulation card:
1. If you are installing an LN03 Plus or a ProCollection card,
turn off the printer. Otherwise, press the Online/Offline key
to take the printer off line (the LED should be off).
CAUTION: Font and emulation cards fit in only one direction, with
the front label facing left, toward the center of the printer. Do not
force them in backwards; this could damage the card and printer.
Chapter 8
8-10 Printer Options