Filter
Top Products
Viglen SX220 User Guide 125
Try the solutions in the order given. If you cannot correct the problem, contact your
service representative or authorised dealer for help.
Power Light Does Not Light
Check the following:
Is the system operating normally? If so, the power LED is probably defective or
the cable from the front panel to the server board is loose.
Are there other problems with the system? If so, check the items listed under
“System Cooling Fans Do Not Rotate Properly.”
If all items are correct and problems persist, contact your service representative or
authorised dealer for help.
No Characters Appear on Screen
Check the following:
Is the keyboard functioning? Check to see that the “Num Lock” light is
functioning.
Is the video monitor plugged in and turned on?
Are the brightness and contrast controls on the video monitor properly adjusted?
Are the video monitor switch settings correct?
Is the video monitor signal cable properly installed?
Is the onboard video controller enabled?
If you are using an add-in video controller board, do the following:
1. Verify that the video controller board is fully seated in the server board connector.
2. Reboot the system for changes to take effect.
3. If there are still no characters on the screen after you reboot the system and
POST emits a beep code, write down the beep code you hear. This information
is useful for your service representative.
4. If you do not receive a beep code and characters do not appear, the video
display monitor or video controller may have failed. Contact your service
representative or authorised dealer for help.
Characters Are Distorted or Incorrect
Check the following:
Are the brightness and contrast controls properly adjusted on the video monitor?
See the manufacturer’s documentation.
Are the video monitor signal and power cables properly installed?