Filter
Top Products
Viglen SX220 User Guide 48
Figure 30: Onboard SCSI Connector
Connecting to a SCSI Controller on a Full-height PCI Card
1. Obtain a SCSI cable with an unfolded length of 26-inches.
2. Flatten the cable and fold it in half beginning about 1-inch from the tape drive end
(see Figure 29, A). Continue folding for a distance of about 10-inches.
3. Fold the cable in half again and secure with electrical tape.
4. Connect the cable to the tape drive (see Figure 31, A) and carefully route the
folded and taped section on the chassis floor between the fan assembly (C) and
the tape drive (A).
5. Connect the cable to the SCSI controller (B) on the full-height PCI card.
Figure 31: Connecting to a Full Height PCI SCSI Controller