Filter
Top Products
Viglen SX220 User Guide 52
Removing the Rails
1. Fully extend a rail assembly (Figure 35). The finger tab (D) for the extension lock
is revealed.
2. Press the finger tab and slide the inside rail (C) from the middle rail (B) until it
completely separates.
NOTE: The middle rail (B) and outer rail (A) cannot be separated.
Figure 35: Removing the Rails
A. Outer rail
B. Middle rail
C. Inner rail
D. Finger tab on extension lock
Attach Inside Rails to Chassis
1. Position an inside rail (Figure 36, A) along one side of the chassis with the finger
tab facing outward and located closer to the rear of the chassis.
2. Align the holes (C) in the rail with the tabs (D) on the chassis and place the rail
against the chassis.
3. Slide the rail as far as it will go toward the front of the chassis to engage the tabs.
4. Fasten the rail to the chassis using screw (B).
5. In the same manner, attach the other inside rail to the other side of the chassis.