Filter
Top Products
Viglen SX220 User Guide 57
6
6
.
.
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
a
a
n
n
d
d
U
U
t
t
i
i
l
l
i
i
t
t
y
y
This chapter describes the Power-On Self-Test (POST) and server configuration
utilities. The table below briefly describes the utilities.
Table 5: configuration Utilities
Utility Description and brief procedure
BIOS Setup Use for system configuration of onboard resources, setting boot device
priority, or setting system security options.
You can move the CMOS jumper on the system board from the default
setting (Protect CMOS memory) to the Clear setting; this will allow most
system configurations to boot.
Changing Boot Device Priority Use this option to change the boot device priority temporarily
permanently.
Adaptec SCSISelect † Utility Use to configure or view the settings of the SCSI host adapters and
onboard SCSI devices in the system.
Direct Platform Control (DPC)
Console
Use to access and monitor the server remotely.
System Setup Utility (SSU) And
Client System Setup Utility (CSSU)
Use for viewing and configuring server management options, viewing
the system event log (SEL), setting boot device priority, or setting
system security options.
The SSU can run either from the configuration software CD or from a set
of bootable diskettes. You can create the diskettes from the CD.
The CSSU is run from the service partition via the DPC console. It
provides the same functionality as the SSU, but from a remote console.
Information entered via the SSU/CSSU overrides information entered
via BIOS Setup.
FRU/SDR Load Utility Use to update the Field Replacement Unit (FRU) and Sensor Record
(SDR) flash components.
NOTE: You must run the FRU/SDR Load utility whenever BMC is
updated or if you change your processors.
BIOS Update Utility Use to update the BIOS or recover from a corrupted BIOS update.
Firmware Update Utility Use to update BMC flash ROM or other firmware.
Hot Keys
Use the keyboard’s numeric pad to enter numbers and symbols.
Table 6: Hot Keys
To do this: Press these keys
Clear memory and reload the
operating systemthis is a system
reset.
<Ctrl+Alt+Del>
Enter the Adaptec SCSI Utility
during POST.
<Ctrl+A> (SCSI model only)
Enter the Promise Technology IDE
RAID Utility.
<Ctrl+F> (ATA model only)
Enter BIOS Setup during POST. <F2>
Abort memory test during POST. <ESC> (Press while BIOS is updating memory size
on screen.)
Display a menu for selecting the
boot device.
<ESC> (Press anytime after memory check.)