Filter
Top Products
Viglen SX220 User Guide 30
Figure 10: Removing the Fan Assembly
Installing the Server Board
1. Ensure that the Mylar insulator sheet is seated securely over the standoffs, is
laying flat on the chassis floor, and that the edge of the sheet is seated below the
studs in the rear chassis wall.
2. Remove the server board from its packaging and antistatic bag.
3. While placing the board on the chassis standoffs, carefully position the board I/O
connectors in the rear chassis I/O openings.
4. Adjust board position so that the two mounting holes near the board edges rest
securely on the two corresponding shouldered standoffs.
NOTE: The three holes on the server board used to mount the board to the standoffs
have white circles around them.
5. Attach the board to the chassis using the three thumbscrews shipped in the
chassis accessory kit.