Filter
Top Products
Viglen SX220 User Guide 49
Connecting to a SCSI Controller on a Low Profile PCI Card
1. Obtain a SCSI cable with an unfolded length of 26-inches.
2. Flatten the cable and fold it in half for the full length, leaving about 1-inch at each
end (see Figure 32).
3. Fold the cable in half again and secure with electrical tape.
4. Connect the cable to the tape drive (see Figure 33, A) and carefully route the
folded and taped section on the chassis floor between the fan assembly (C) and
the tape drive (A).
5. Connect the cable to the SCSI controller (B) on the low-profile PCI card.
Figure 32: SCSI Cable Length Required
Figure 33: Connecting to a half Height PCI SCSI Controller
Installing a COM 1 port in the Rear I/O
Using a standard DH-10 to DB-9 COM cable, you may install a COM 1 port in the
opening provided in the rear I/O (see Figure 3, C, on page 9). Connect the other end
to the COM 1 serial port header on the server board (see Figure 4 on page 13)