Filter
Top Products
5-15. Reset
121 II Network Setup - Administrators only
Chapter 5 Web Utility
Resetting the Network Function
Re-boot only the network function to enable the newly set parameter values.
zThis function will not reset the copier or controller. Should you wish to reset the copier or controller, turn off the main
power supply, wait at least ten seconds, then reboot the power.
To reset the Network function, follow these steps:
1 Open the Reset page.
2 At the bottom of the page, type in the system password in the provided field.
3 Click the Reset option box. The following dialog box will appear:
The Unit is now being reset. Allow 2 minutes before reconnecting.
4 Wait two minutes, then reconnect.
Restoring the Factory Defaults
This feature allows you to switch all settings on the network function back to their factory default (initial) set-
tings. Use this feature when operating a copier in a new environment to clear all settings values. Note that the
serial number and the MAC address of the network function will not be cleared.
Should you wish to restore Web Server’s factory default settings, follow these steps:
1 Open the Reset page.
2 At the bottom of the page, type in the system password in the provided field.
3 Click the Restore Factory Defaults option box.