Filter
Top Products
1-12 Copy Functions
Margin Mode
You can shift the original image to make space on the copy for binding
on the left (right) or top (bottom) side. Margin widths are as follows.
Margin on the Back Side
When duplexing, you can also specify the margin on the back side.
Auto – Automatically sets margins to match the front side setting. When
[Auto] is specified, the left and right margins on the front are reversed on
the back. In other words, when the left margin of the front side is set to
1/2" (10 mm), the back side right margin is set to 1/2" (10 mm). The top
and bottom margin widths on the back will match those on the front.
Separate Front/Back Margins – Enables you to specify the front and
back settings separately.
Follow the steps as below to use the Margin mode.
1 Place the original so the top edge is aligned with the back or left of
the platen.
2 Press [Function].
3 Press [Margin/Centering].
4 Press [Margin].
5 Press [S], [T], [W] or [X] to adjust the top, bottom, left and right
margins.
6 For duplex copying, press [Back page margin].
7 Press [Auto] or [Front/Back margin].
[Auto] specifies the margin on the back side automatically based on
the front margin.
For [Front/Back margin], press [S], [T], [W] or [X] to adjust the top,
bottom, left and right margins.
8 Depending on the placed original, select [Top Edge Top] or [Top
Edge Left] from Select Original Orientation.
9 Press the Start key. Copying begins.
Model Type Range
Inch models 0 - 3/4" (1/8" increments)
Metric models 0 - 18 mm (1 mm increments)
Note You can set the default margin width. For further details,
refer to Setting Margin Defaults on page 3-8.
Ba
Sel
e
Off
Margin
Ori
e
T
o
Margin/Centering
Centering
Front page
Left
Back page
margin
Auto
(0~¾)
"
"
(0~¾)
Ready to copy.
.0
¼
Shortcut
T
o
Ba
c
Sel
e
Auto
Front/Back
Ori
e
Back page margin
Back page
margin
"
"
Ready to copy.
(0~¾)
(0~¾)
T
o
T
o