Filter
Top Products
Dial Registration
Enhanced Utilities 6 - 13
•
The initial screen is displayed.
•
If you want to continue registering for Program Dial, press another unused "One Touch"
key from 24, 25, 26, and 27.
Using the Program Dial
1
Check that the message "SET DOC. FACE UP" is shown on the Message Display.
If not, press the “Copy/Fax” key to switch.
2
Press the "One Touch" key in which the desired Program Dial has been registered.
•
For example: "One Touch" key 27→ Timer TX
•
The machine starts scanning.
•
After completely scanning the document, the machine enters the standby state for timer
transmission while showing the initial screen on the Message Display.
Using Batch TX
You can program your single location one-touch keys to batch documents automatically.
By assigning a batch time to a programmed one-touch key, you can eliminate dialing the same
number several times a day. Your fax unit calls the other unit at a preset time and transmits all
documents stored in memory during the same call.
Setting up the BATCH TX
1
Press "Program" key 3 times.
2
Press ‘5’ of the Keypad. The message “5BATCH TX” is displayed briefly to confirm your
selection.
3
Press the “One-Touch” key that you want to program.
Before you use the Batch feature, you have to program the telephone number for the one-
touch key the display will show the number.
4
Enter the batch time using the Keypad then press the "Yes" key.
•
If you want to cancel Batch TX, press the "No/Clear" key.
•
Then press the "Yes" key.