Lantronix XPort AR Network Card User Manual


 
4: Configuration Using Web Manager
XPort AR User Guide 31
2. Enter or modify the following fields:
Mode Select Disabled to turn off connect mode. Any Character
enables connect mode upon receiving a character. Start
Character enables connect mode upon receiving the start
character. Select DSR Active to enable Connect Mode if
Data Set Ready (DSR) pin is active on the serial line. Select
Modem Emulation to use modem emulation on this tunnel.
Remote Address
Enter the remote address to which the XPort AR will connect.
Enter an IP address or DNS name.
Remote Port
Enter the remote port number.
Local Port
Enter the port for use as the local port. A random port is
selected by default.
Protocol
Select the protocol type for use in command mode. TCP is
the default protocol.
Reconnect Timer
Enter the reconnect time in milliseconds. The XPort AR
attempts to reconnect this amount of time after failing a
connection or exiting an existing connection.
SSH Username
Enter the SSH username. The tunnel uses the SSH keys for
the client username.
Block Serial Data Select On to block (not tunnel) serial data transmitted to the
XPort AR.
Block Network Data Select On to block (not tunnel) network data transmitted to the
XPort AR.
TCP Keep Alive
Enter the time, in milliseconds, the unit waits during a silent
connection before checking if the currently connected network
device is still on the network. If the unit then gets no response
after 8 attempts, it drops that connection.
CP Set Group
Identifies a CP or CP Group whose value should change
when a connection is established and dropped.
On Connection
Specifies the value to set the CP or CP Group when a
connection is established.
On Disconnection
Specifies the value used when the connection is closed.
3. Click Submit. Changes are applied immediately to the XPort AR.
Accept Mode
In accept mode, the XPort AR listens (waits) for incoming connections.
To configure the tunnel’s accept mode:
1. Click Tunnel 1 Æ Accept Mode from the navigation menu. The Tunnel 1 Accept
Mode window displays.