Filter
Top Products
manufacturer. If your system has a module containing a lithium battery, replace it only with the same
module type made by the same manufacturer. The battery contains lithium and can explode if not
properly used, handled, or disposed of. Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the replacement battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the replacement battery.
2. Insert the new battery:
a. Orient the battery so that the positive side faces up.
b. Tilt the battery so that you can insert it into the socket on the side opposite the battery clip.
c. Press the battery down into the socket until it clicks into place. Make sure that the battery clip holds
the battery securely.
3. Make sure that the riser-card assembly is fully seated in the connectors on the system board.
4. If the riser-card assembly is an optional PCI-X riser-card assembly, make sure that the riser-card power
cable 1 is connected to the riser-card assembly.
5. Install the cover (see “Removing and installing the cover” on page 119).
6. Slide the server into the rack.
7. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices and
the server.
Note: You must wait approximately 1 to 3 minutes after you connect the power cord of the server to an
electrical outlet before the power-control button becomes active.
8. Start the Setup utility and reset the conguration (see “Starting the Setup Utility” on page 198 for details).
• Set the system date and time.
• Set the power-on password.
• Recongure the server.
152 Hardware Maintenance Manual