Filter
Top Products
• Load Default Settings
Select this choice to cancel the changes that you have made in the settings and restore the factory
settings.
• Exit Setup
Select this choice to exit from the Setup Utility. If you have not saved the changes that you have made in
the settings, you are asked whether you want to save the changes or exit without saving them.
Passwords
From the System Security choice, you can set, change, and delete a power-on password and an
administrator password. The System Security choice is on the full Conguration/Setup Utility menu only.
If you set only a power-on password, you must type the power-on password to complete the system startup;
you have access to the full Conguration/Setup Utility menu.
An administrator password is intended to be used by a system administrator; it limits access to the full
Conguration/Setup Utility menu. If you set only an administrator password, you do not have to type a
password to complete the system startup, but you must type the administrator password to access the
Conguration/Setup Utility menu.
If you set a power-on password for a user and an administrator password for a system administrator, you can
type either password to complete the system startup. A system administrator who types the administrator
password has access to the full Conguration/Setup Utility menu; the system administrator can give the user
authority to set, change, and delete the power-on password. A user who types the power-on password
has access to only the limited Conguration/Setup Utility menu; the user can set, change, and delete the
power-on password, if the system administrator has given the user that authority.
Power-on password
If a power-on password is set, when you turn on the server, the system startup will not be completed until
you type the power-on password. You can use any combination of up to seven characters (A - Z, a - z,
and 0 - 9) for the password.
If a power-on password is set, you can enable the Unattended Start mode, in which the keyboard and
mouse remain locked but the operating system can start. You can unlock the keyboard and mouse by
typing the power-on password.
If you forget the power-on password, you can regain access to the server in any of the following ways:
• If an administrator password is set, type the administrator password at the password prompt (see
“Administrator password” on page 201
). Start the Conguration/Setup Utility program and reset the
power-on password.
• Remove the battery from the server and then reinstall it. For instructions for removing the battery, see
“Replacing the system-board battery” on page 150.
• Change the position of the clear CMOS jumper on the system board
to bypass the power-on password
check. See “Power-on password” on page 201
for additional information.
Attention: Before you change any switch settings or move any jumpers, turn off the server; then, disconnect
all power cords and external cables. See the safety information in “Important Safety Information” on page 1
and “Guidelines for trained service technicians” on page 115. Do not change settings or move jumpers on
any system-board switch or jumper block that is not shown in this document.
Administrator password
If an administrator password is set, you must type the administrator password for access to the full Setup
utility menu. You can use any combination of up to seven characters (A - Z, a - z, and 0 - 9) for the password.
Chapter 8. Conguring the server 201