Filter
Top Products
00
00
00
00000000
00000000
00000000
00000000
1
Connectors
2
Guide channels
1. Connect the power cable to the replacement backplane or back plate.
2. Reconnect the backplane or back plate cables:
• If the server is a hot-swap model, reconnect the SAS/SATA controller signal cable to the backplane.
• If the server is a simple-swap model that contains a standard SATA back plate, reconnect the SATA
cable to the system board. See “System-board internal connectors” on page 108 for the location
of the SATA connectors on the system board.
Note: Make sure that the cable drive number on the back plate matches the SATA connector number
on the system board.
• If the server is a simple-swap model that contains a SATA RAID back plate, reconnect the SAS
signal cable to the SAS/SATA controller.
3. Slide the backplane or back plate into the card guides, making sure that any nearby wires or cables
are not trapped or pinched.
4. Press rmly until the backplane or back plate is fully seated.
5. Install the hard disk drives.
6. Go to “Completing the FRU replacement” on page 172.
154 Hardware Maintenance Manual