Filter
Top Products
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 7 “Parts listing, RS210 Types 6531, 6532, 6533, and 6534” on page 175 to determine which
components are customer replaceable units (CRU) and which components are eld replaceable units (FRU).
• If an action step is preceded by “(Trained service technician only),” that step must be performed only by
a trained service technician.
• Go to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information,
hints, tips, and new device drivers or to submit a request for information.
Error code Description Action
3048005
Booted secondary (backup) UEFI image
Information message that the backup UEFI settings
are used.
3048006
Booted secondary (backup) UEFI image
because of ABR
1. Run the Setup utility, select Load Default Settings,
and save the settings to recover the primary UEFI
settings.
2. Turn off the server and remove it from the power
source.
3. Reconnect the server to the power source, then
turn on the server.
305000A
RTC date/time is incorrect 1. Adjust the date and time settings in the Setup
utility, and then restart the server.
2. Reseat the battery.
3. Replace the following components one at a time, in
the order shown, restarting the server each time:
a. Battery
b. (Trained service technician only) System board
3058001
System conguration invalid
1. Run the Setup utility, and select Save Settings.
2. Run the Setup utility, select Load Default Settings,
and save the settings.
3. Replace the following components one at a time, in
the order shown, restarting the server each time:
a. Battery
b. Failing device (if the device is a FRU, it must be
replaced by a trained service technician only)
c. (Trained service technician only) System board
3058004
Three boot failure
1. Undo any recent system changes, such as new
settings or newly installed devices.
2. Make sure that the server is attached to a reliable
power source.
3. Make sure that the operating system is not
corrupted.
4. Run the Setup utility, save the conguration, and
then restart the server.
5. See “Problem determination tips” on page 104.
3108007
System conguration restored to default
settings
Information only. This message is usually associated
with the CMOS battery clear event.
3138002
Boot conguration error
1. Remove any recent conguration changes made
to the Setup utility.
2. Run the Setup utility, select Load Default Settings,
and save the settings.
24 Hardware Maintenance Manual