Filter
Top Products
Configuring the Location Table
8-2 PortMaster Configuration Guide
Locations can also optionally have the following settings:
• Connection type (dial-on-demand, continuous, or manual)
• Routing protocol
• IPX network number
•MTU size
• Compression
•Idle timer
• Data-over-voice for ISDN connections
• CHAP authentication
• Asynchronous character map
• Multiline load balancing
Note – The location table is not used for dialing out with the tip command or UUCP.
For information on these applications, refer to Chapter 18, “Accessing Shared Devices.”
To display the location table, enter the following command:
Command> show table location
A location table display looks like the following. The location table entries shown here
are examples only. PortMasters have empty locations tables by default.
Location Destination Netmask Group Maxcon Type
----------- ----------------- ---------------- -------- ---------- --------------
hq 172.16.1.1 255.255.255.0 1 4 On Demand
sf 192.168.1.21 255.255.255.0 99 1 Manual
sub1 192.168.3.1 255.255.255.0 2 0 Manual
bsp 172.16.1.21 255.255.255.0 99 1 Manual
✍