Filter
Top Products
Configuration Steps for a Frame Relay Connection
13-10 PortMaster Configuration Guide
Configuring Ethernet Interface Settings
Configure the Ethernet interface settings to the values shown in Table 13-4.
After you configure the Ethernet interface as shown in Table 13-4, enter the following
command to save the configuration:
Command> save all
For more information on Ethernet parameters, refer to Chapter 4, “Configuring the
Ethernet Interface.”
Configuring Synchronous WAN Port Settings
Configure the synchronous WAN port W1 to the values shown in Table 13-5.
Table 13-4
Ethernet Values
Setting Command
IP address set
ether0
address
92.168.1.1
Netmask set
ether0
netmask
255.255.255.0
Broadcast address set
ether0
broadcast
high
RIP routing set
ether0
rip on
Table 13-5
WAN Port Parameter Values
Setting Command
Port type set
w1
network
hardwired
Protocol set
w1
protocol
frame
Port IP address set
w1
address
92.168.1.20.2
Netmask set
w1
netmask
255.255.255.0
Modem control set
w1
cd on
RIP routing set
w1
rip
listen
Annex-D set
w1
annex-d
10
(LMI can be used instead of Annex-D)