Filter
Top Products
Configuration Steps for Shared Device Access
18-8 PortMaster Configuration Guide
Parallel Port (P0) Settings
You can also configure the parallel port P0 to access a printer. To configure the P0 port
for a printer, use the values shown in Table 18-5.
Leave all other settings at their default values.
After you have configure port P0 as shown in Table 18-5, enter the following commands
to reset the port and save the configuration:
Command> reset P0
Command> save all
Configuring a Network Device for Telnet Access
To access modems or other devices attached to PortMaster ports via Telnet, use the
general configuration given earlier in this chapter but use the settings shown in
Table 18-6. This example is for port S1.
After resetting port S1, you can access it using Telnet from your host or by entering the
following commands:
Command> reset s1
Command> telnet pm1 6001
Table 18-5
Parallel Port (P0) Values
Setting Command
Port type set
P0
device /dev/ttyre
Host set
P0
host
default
Device service set
P0
service_device
portmaster
Table 18-6
Serial Port Values to Allow a Telnet Connection to Ports S0 through S29
Setting Command
Port type set
s1
device
/dev/network
Modem control set
s1
cd off
Device service set
s1
service_device
telnet
6001