Filter
Top Products
Configuration Steps for an Office-to-Office Connection
15-10 PortMaster Configuration Guide
Configuring a Dial-In User
A user account must be set up on the PortMaster in Paris so the Office Router in the
London can dial in when traffic is queued. The new user london should be configured
with the values shown in Table 15-8.
After you configure the user table as shown in Table 15-8, enter the following command
to save the configuration:
Command> save all
For more information about configuring user table settings, refer to Chapter 7,
“Configuring Dial-In Users.”
Table 15-8
User Table Values
Setting Command
Username add netuser
london
Password set user
london
password
anypasswd
Protocol set user
london
protocol ppp
User IP address set user
london
destination
192.168.200.1
Netmask set user
london
netmask
255.255.255.0
IPX network set user
london
ipxnet
F2
(When configuring the IPX network number for the dial-in user,
you must set a number that is different from the one on the
Ethernet at either end.)
RIP routing set user
london
rip on
MTU set user
london
mtu
1500
Compression set user
london
compression on