Filter
Top Products
Configuration Steps for a Synchronous V.25bis Connection
14-6 PortMaster Configuration Guide
After you configure user table settings as shown in Table 14-4, enter the following
command to save the configuration:
Command> save all
No compression is used on synchronous lines. For more information about configuring
user table settings, refer to Chapter 7, “Configuring Dial-In Users.”
Configuring a Dial-Out Location
A location entry on the PortMaster in Boston must be created for the location identified
as
miami
. This allows the PortMaster in Boston to call the PortMaster in Miami when
network traffic is queued. The new location
miami
should be configured on the router in
Boston with the values shown in Table 14-5.
IPX network set user
miami
ipxnet
F3
RIP routing set user
miami
rip on
MTU set user
miami
mtu
1500
Table 14-5
Location Table Values
Setting Command
Location name add location
miami
Type set location
miami manual
(Set the location for manual dialing until after the
configuration has been tested. Once the configuration is
verified, change the connection type to on-demand.)
Protocol set location
miami
ppp
IP destination set location
miami
destination
192.168.1.1
Netmask set location
miami
netmask
255.255.255.0
IPX network set location
miami
ipxnet
F3
RIP routing set location
miami
rip on
MTU set location
miami
mtu
1500
Table 14-4
User Table Values
(Continued)
Setting Command