Filter
Top Products
Advanced fax
Programming regular polling
Note: You cannot program continuous polling into a programmable one-touch key.
For more information on continuous polling, see page 3.35.
To program a regular polling operation into a programmable one-touch key:
1
Press
MENU
,
C
, [Enter].
The
LCD
shows the programmable one-touch
number list.
2
Select the programmable one-touch number
that you want to program or change.
Note: If you’re changing a previously stored command:
If your previous command for this key was a polling transmission and
you want to keep this key programmed for a polling transmission, use
these instructions to make changes.
If you want to assign this key to a completely different operation,
overwrite a previously stored command to the new one.
3
Press [Enter].
4
Use the numeric keypad to enter the fax num-
ber exactly as your machine should dial it,
including whatever codes your phone system
requires. The number can be up to 40 charac-
ters in length.
5
Press [Enter].
6
Select “Polling” and press [Enter].
7
If you want the polling to begin immediately every time you press the key,
press [Exit] and skip to step 10.
If you want to delay the polling, select “Delayed Tx” and press [Enter].
8
Next, tell your fax to carry out this delayed command one of these ways:
Option 1: Perform the command once at a
certain time on a certain day of
the month. (For example, “Do this
at 5:05
PM
on the 30th.”)
To select this option, use the
numeric keypad to enter the date
and time when the fax should perform the command.
Option 2: Perform the command at a cer-
tain time each day you press the
key. (For example, “Do this at 5:05
PM
today.”)
To select this option, use the
numeric keypad to enter 0, 0 and
then the time the fax should per-
form the command.
9
Press [Enter], [Exit].
10
The machine will return to step 2.
Note: When regular polling is programmed, the symbol will appear in
the programmable one-touch number list on the
LCD
.
Note: When the delayed transmission is programmed, the symbol will
appear in the programmable one-touch number list on the
LCD
.
If you want to enter or change another key’s programming, repeat steps 2-10.
If you do not want to enter or change any other key’s programming, press
RESET
. Your machine returns to standby mode.
3.56