Filter
Top Products
4-14 Chapter 4: 7401-4xxx Hardware Installation
Note: The printhead lever must be closed for auto-loading to
function.
Removing Paper from the Printer Feed Rolls
If paper becomes jammed in the printer feed rolls:
1. Unlock the cabinet Keylock.
2. Raise the bottom of the Display Module Door until fully open and
supported by the Gas Shock.
3. Slide the Keyboard Tray forward until it stops.
4. Lift the printhead lever.
5. Loosen the two thumb screws and remove the Front Paper Guide
Cover.
6. Remove the paper.
Note: You can also feed paper manually using the Form Feed button
on the Printer Switch and Display Panel. Refer to the “Using the Printer
Test and Display Panel” section for details.
Removing Power from the Printer
The printer has an On/Off switch located on the back of the printer
and has a separate Power Supply located under the printer. The Printer
Power Supply is plugged into the bottom connector of the Power Strip
inside the terminal cabinet. Use either of the following methods to
remove power:
• Press the On/Off Switch to the Off position.
• Unplug the Printer Power Supply plug from the Power Strip.