Filter
Top Products
Chapter 4: 7401-4xxx Hardware Installation 4-23
Note: If you are installing 7401-4xxx on the EasyPoint 45 Pedestal, the
UPS must be installed first. See 2336-K045 Feature Kit for more
information.
Installing the Power Mon II Software
The Power Mon II software is provided on CD-ROM and may be
installed over a network or using an integrated or parallel CD-ROM
drive. All operating system versions of the Power Mon software and
installation documentation are contained on the CD.
The Power Mon installation should auto start. If it doesn’t, browse the
CD for the operating system you are using and run Setup.exe for that
operating system. Follow the prompts to install the software.
Note: When you are prompted for Configuration Code, enter 7 to
identify the interface cable type.
Configuring the Power Mon II Software
Once Power Mon is installed, configure the software by clicking on the
Power Mon icon. Select “Configure UPS” to configure the UPS
parameters such as voice messages and battery run time.
Note: Battery run time for the 4055 UPS running with a 7401-4xxx and
a Full-page Thermal Printer at a load of 150 VA is approximately:
Item Approximate Battery Run Time
300 VA (180 W) 13 minutes*
500 VA (300 W) 23 minutes*
* Times are approximate and may vary due to modified configurations,
environmental conditions, ambient temperature, battery age, and other
factors.
Reference NCR EasyPoint 7401Site Preparation (B005-0000-1255) for
additional power requirements for the 7401.